Install Instructions for PRP Seats Pro XP Front Door Bag
Page 2 of 3
1. Remove the stock bolts from the door
(shown in picture).
Use a T-40 Socket to remove the 11
bolts that connect the door‘s metal
frame to the outside plastic panel.
Once the bolts are removed, take off
the plastic panels.
3. Place the bag in-between the metal
frame and the plastic panel.
Push upper and lower storage
compartments through the open
sections in the frame.
2. Select the appropriate door bag for the
door you are installing on (Driver or
Passenger).
The bottom storage compartment on
each bag has a foam cushion inside it.
Remove this foam cushion while you
install. Simply open the zipper and pull
the foam out.
4. Line up the cut-holes on the bags liner,
with the corresponding bolt holes on the
frame and plastic panel. Re-install the
bolts so that the bag is secured between
the door’s frame and plastic panel.
TIP: Start by the door latch, then re-install the
bolts one by one (The bolts tend to fall out if
you place them in loose all in at once).